Its actually really simple. But not written down anywhere.
On your panel
Get into programming.
(INSTALLER CODE)800 Default installer code is 4112. So Verbatum you press 4112800 if the installer code is default.
Move to The enable IP/GSM Field by pressing *29
Press 1 to enable the Device.
Press the * to Go Back after you enable.
Now press *54
Its currently set to 54 change it to 1 by pressing 1
press * to go back.
Now Press *55 on the keypad.
Its currently set to 55 change it to 1 by pressing 1
Now press* to Exit out of the mode.
Now press Now press*99 to exit your panel and Restart the chip when it returns will start system ready.
Shortly after that you will see This error message about Check 103.
This means that the Device is reporting no monitoring services. This is where you will then proceed to Alarm-net.
#honeywell #security #AlarmNet